Browsing by Author "Bourauel, Christoph"

Now showing 1 - 2 of 2

Digital assessment of properties of the three diferent generations of dental elastomeric impression materials
(BioMed Central Ltd., 2022-09) Singer, Lamia; Habib, Shaymaa I; Shalaby, Heba El‑Amin; Saniour, Sayed H; Bourauel, Christoph
Background: This study aimed to compare the dimensional accuracy, hydrophilicity and detail reproduction of the hybrid vinylsiloxnether with polyether and polyvinylsiloxane parent elastomers using modifed digital techniques and software. This was done in an attempt to aid in solving the confict between the diferent studies published by competitive manufacturers using diferent common manual approaches. Methods: A polyether, polyvinylsiloxanes and vinyl polyether silicone hybrid elastomeric impression materials were used in the study. Dimensional accuracy was evaluated through taking impressions of a metallic mold with four posts representing a partially edentulous maxillary arch, that were then poured with stone. Accuracy was calculated from the mean of measurements taken between fxed points on the casts using digital single-lens refex camera to produce high-resolution digital pictures for all the casts with magnifcation up to 35×. Hydrophilicity was assessed by contact angle measurements using AutoCAD software. The detail reproduction was measured under dry conditions according to ANSI/ADA Standard No. 19 and under wet conditions as per ISO 4823. A metallic mold was used with three V shaped grooves of 20, 50, and 75 µm width. Specimens were prepared and examination was made immedi‑ ately after setting using digital images at a magnifcation of 16×. Results: The hybrid impression (0.035 mm) material showed signifcantly higher dimensional accuracy compared to the polyether (0.051 mm) but was not as accurate as the polyvinyl siloxane impression material (0.024 mm). The contact angles of the hybrid material before and after setting was signifcantly lower than the parent materials. With regard to the detail reproduction, the three tested materials were able precisely to reproduce the three grooves of the mold under dry conditions. Whereas, under wet conditions, the hybrid material showed higher prevalence of well-defned reproduction of details same as polyether but higher than polyvinylsiloxane that showed prevalence of details with loss of sharpness and continuity. Conclusions: The digital technique used could be a more reliable and an easier method for assessment of impres‑ sion materials properties. The hybridization of polyvinyl siloxane and polyether yielded a promising material that combines the good merits of both materials and overcomes some of their drawbacks.
Tear strength and elastic recovery of new generation hybrid elastomeric impression material: A comparative study
(BioMed Central Ltd., 2022-06) Singer, Lamia; Bourauel, Christoph; Habib, Shaymaa I; Shalaby, Heba El‑Amin; Saniour, Sayed H
Objective: Since there is no material in the market met all the ideal requirements of an impression material, thus in an attempt to fnd one, hybridization between the two most commonly used impression materials were done. The aim of the hybridization was to obtain a new material combining the good merits of both and eliminate their short‑ comings. Thus, this study aimed to assess the impact of hybridization between polyether with addition silicone on tear strength and elastic recovery of the new material and compare such efect with regard to parent materials. Results: A polyether (PE), polyvinyl siloxanse (PVS) and vinyl polyether silicone (VPES) hybrid elastomers were used in the present study. Tear strength was measured one hour after setting time of each material according to the manufac‑ turer and the three materials showed statistically comparable tear strength in N/mm. Elastic recovery was evaluated one minute after the setting time recommended by the manufacturer. The three materials were statistically insignif‑ cant from each other, and all met the ISO4823 requirement of having greater than 96.5% recovery.