Browsing by Author "Mokhtar, Ahmed"

Filter results by typing the first few letters
Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Electronic compensation of capacitive micro-machined sensors parasitic modes in force-feedback interface systems
    (United States Patent US8872683B2, 2014) Ismail, Ayman; Elshennawy, Ahmed; Mokhtar, Ahmed; Elsayed, Ayman
    Operating capacitive sensors in force feedback mode has many benefits, such as improved bandwidth, and lower sensitivity to process and temperature variation. To overcome, the non-linearity of the voltage-to-force relation in capacitive feedback, a two-level feedback signal is often used. Therefore, a single-bit Σ-Δ modulator represents a practical way to implement capacitive sensors interface circuits. However, high-Q parasitic modes that exist in high-Q sensors (operating in vacuum) cause a stability problem for the Σ-Δ loop, and hence, limit the applicability of Σ-Δ technique to such sensors. A solution is provided that allows stabilizing the Σ-Δ loop, in the presence of high-Q parasitic modes. The solution is applicable to low or high order Σ-Δ based interfaces for capacitive sensors
  • Thumbnail Image
    Item
    Interface for MEMS inertial sensors
    (Shenzhen Goodix Technology Co Ltd, 2013) Elsayed, Ayman; Elmallah, Ahmed; Elshennawy, Ahmed; Shaban, Ahmed; George, Botros; Elmala, Mostafa; Ismail, Ayman; Sakr, Mostafa; Mokhtar, Ahmed
    In a high-performance interface circuit for micro-electromechanical (MEMS) inertial sensors, an excitation signal (used to detect capacitance variation) is used to control the value of an actuation signal bit stream to allow the dynamic range of both actuation and detection paths to be maximized and to prevent folding of high frequency components of the actuation bit stream due to mixing with the excitation signal. In another aspect, the effects of coupling between actuation signals and detection signals may be overcome by performing a disable/reset of at least one of and preferably both of the detection circuitry and the MEMS detection electrodes during actuation signal transitions. In a still further aspect, to get a demodulated signal to have a low DC component, fine phase adjustment may be achieved by configuring filters within the sense and drive paths to have slightly different center frequencies and hence slightly different delays.