El Hossainy, Tarek MZeyada, YasserAbdelkawy, Abdallah2023-02-032023-02-032023-01https://doi.org/10.1186/s44147-023-00174-zhttp://repository.msa.edu.eg/xmlui/handle/123456789/5333This work introduces an approach for optimization machinability measures of power consumption, machining time, and the surface roughness (PMS). This approach is starting with market customer’s demands, passing by optimizing the machinability measures (PMS), and ending by the optimized cutting conditions. The fuzzy logic was used to defne the weights of each of required machinability measurement using method through expert rules depending on factory requirements. Genetic algorithm was formulated for giving optimum output values based on the customer’s demands. A neural network was designed for controlling the input cutting conditions with the PMS output parameters. The proposed soft computing technique creates reasonable results compared to experimental results and gives rich investigations for optimizing the output parameters not only for increasing productivity and quality demands but also for saving power consumed. The variation of consumed power, machining time, and surface roughness was calculated based on diferent customer demand levels. When the machining time and power consumed importance increased, the proposed technique reduced them by about 20% and 10% for the testes case.en-USMachining,Machining power,Machining time,Surface roughness,Surface quality,Optimization, Fuzzy logic, Neural network, Genetic algorithmFuzzy logic,Neural network,Genetic algorithmArticlehttps://doi.org/10.1186/s44147-023-00174-z